HP T2500 manual Dhcp Renew

Menu item	Sub-menu item	Sub-menu item	Values and Description
		DHCP Renew	This menu appears if Config Method was set to DHCP and
			a DHCP lease for the print server exists.
			No (default): The print server does not request to renew
			the DHCP lease.
			Yes: The print server requests to renew the current DHCP
			lease.
		Manual Settings	(Available only if Config Method is set to Manual)
			Configure parameters directly from the printer control
			panel:
			IP Address: The unique IP address of the printer (n.n.n.n).
			Subnet Mask: The subnet mask for the printer (n.n.n.n).
			Syslog Server: The IP address of the syslog server
			(n.n.n.n) used to receive and log syslog messages.
			Default Gateway: The IP address (n.n.n.n) of the gateway
			or router used for communications with other networks.
			Idle Timeout: The time period, in seconds, after which an
			idle TCP print data connection is closed (default is 270
			seconds, 0 disables the timeout).
		Default IP	Specify the IP address to default to when the print server
			is unable to obtain an IP address from the network during
			a forced TCP/IP reconfiguration (for example, when
			manually configured to use BootP or DHCP).
			Auto IP: A link-local IP address 169.254.x.x is set.
			Legacy: The address 192.0.0.192 is set, consistent with
			older HP Jetdirect devices.
		Primary DNS	Specify the IP address (n.n.n.n) of a Primary DNS Server.
			NOTE: This item appears only if Manual configuration is
			a higher priority than DHCP in the Config. Precedence
			table, configured through the embedded Web server.
		Secondary DNS	Specify the IP address (n.n.n.n) of a Secondary Domain
			Name System (DNS) Server.
			NOTE: This item will appear only if Manual
			configuration is a higher priority than DHCP in the Config.
			Precedence table, configured through the embedded
			Web server.
	IPV6 Settings	Enable	Use this item to enable or disable IPv6 operation on the
			print server.
			Off: IPv6 is disabled.
			On (default): IPv6 is enabled.
		Address	Use this item to manually configure an IPv6 address.
			Manual Settings: Use the Manual Settings menu to enable
			and manually configure a TCP/ IPv6 address.
			Enable: Select this item and choose On to enable manual
			configuration, or Off to disable manual configuration.
			Address: Use this item to type a 32 hexadecimal digit IPv6
			node address that uses the colon hexadecimal syntax.

40 Chapter 4 Network configuration ENWW