To turn it back on, use the power switch at the rear.
When the printer is powered back on, it takes about 3 minutes to initialize and check and prepare the printhead. Preparing the printhead takes about 75 seconds. However, if the printer has been off for 2 weeks or more, preparing the printhead could take up to 7 minutes, plus 13 minutes if it needs a printhead recovery.
See also Sleep mode on page 10 and Change the
The printer’s internal prints
The internal prints give various kinds of information about your printer. They can be requested from the front panel.
Before requesting any internal print, check that the printer and the paper are ready for printing.
●The loaded paper should be at least A3
●The front panel should be displaying the Ready message.
To print any internal print, press , then , then scroll down to Internal prints and press it, then select the internal print you want. The following internal prints are available.
●Demo prints show some of the capabilities of the printer
◦Print drawing demo
◦Print rendering demo
◦Print GIS map
●User information prints
◦Usage report shows estimates of the total number of prints, number of prints by paper type, number of prints by
◦
◦PostScript font list shows PostScript fonts available (PostScript printers only)
●Service information prints
◦Print current information
◦Print usage information
◦Print event logs
◦Print calibration status
ENWW | The printer’s internal prints 13 |