Menu item | Values and Description | ||
|
|
|
|
IPSEC |
|
| Specify the IPsec or Firewall status on the print server. |
|
|
| Keep: IPsec/Firewall status remains the same as |
|
|
| currently configured. |
|
|
| Disable: IPsec/Firewall operation on the print server is |
|
|
| disabled. |
|
|
|
|
Reset Security |
|
| Specify whether the current security settings on the print |
|
|
| server will be saved or reset to factory defaults. |
|
|
| No (default): The current security settings are |
|
|
| maintained. |
|
|
| Yes: Security settings are reset to factory defaults. |
|
|
|
|
Link Speed |
|
| The link speed and communication mode of the print |
|
|
| server must match the network. The available settings |
|
|
| depend on the device and installed print server. Select |
|
|
| one of the following link configuration settings: |
|
|
| CAUTION: If you change the link setting, network |
|
|
| communications with the print server and network device |
|
|
| might be lost. |
|
|
| Auto (default): The print server uses |
|
|
| configure itself with the highest link speed and |
|
|
| communication mode allowed. If |
|
|
| either 100TX HALF or 10TX HALF is set depending on the |
|
|
| detected link speed of the hub/switch port. (A 1000T |
|
|
| |
|
|
| 10T Half: 10 Mbps, |
|
|
| 10T Full: 10 Mbps, |
|
|
| 100TX Half: 100 Mbps, |
|
|
| 100TX Full: 100 Mbps, |
|
|
| 100TX Auto: Limits |
|
|
| speed of 100 Mbps. |
|
|
| 1000TX Full: 1000 Mbps, |
|
|
|
|
Embedded services
Key networking services embedded in the printer are listed below. For the latest features and services, visit http://www.hp.com/go/jetdirect.
●Configuration and Management
◦BootP/DHCP (IPv4 only)
◦DHCPv6
◦TFTP (IPv4 only)
◦Web Proxy (Automatic/Manual cURL)
◦LLMNR
◦Telnet (IPv4 only)
◦SNMP (v1, v2c, v3) agents
42 Chapter 4 Network configuration | ENWW |