HP T2500 manual Recalibrating the paper advance procedure

rate at which the paper advances. See Troubleshooting print-quality issues on page 182 for steps to determine if paper advance calibration will solve your issue.

You can check the paper advance calibration status of the currently loaded paper at any time from the front

panel. Press , then , then Image quality maintenance > Calibration status. The status may be

one of the following.

●DEFAULT: This status appears when loading any paper that has not been calibrated. HP papers in the Front Panel have been optimized by default and unless you experience image quality problems in your printed image such as banding or graininess it is not recommended to recalibrate the paper advance.

●OK: This status indicates that the loaded paper has been calibrated before. However you may need to repeat the calibration if you experience image quality problems such as banding or graininess in your printed image.

NOTE: Whenever you update the printer’s firmware, the paper advance calibration values are reset to factory default, see Update the firmware on page 153.

CAUTION: Transparent papers and films must be calibrated by pressing , then , then Image

quality maintenance > Paper advance calibration > Adjust paper advance, from step four in Recalibrating the paper advance procedure.

Recalibrating the paper advance procedure

1.From the front panel, press , then , then Image quality maintenance > Paper advance calibration > Calibrate paper advance. The printer automatically recalibrates the paper advance and prints a paper advance calibration image, which you can send to stacker or basket.

2.Wait until the front panel displays the status screen, then reprint your print.

NOTE: The recalibration procedure takes a few minutes. Do not worry about the paper advance calibration image. The front-panel display shows any errors in the process.

If you are satisfied with your print continue using this calibration for your paper type. If you see improvement in your print, continue with step three. If you are dissatisfied with the recalibration, return to the default calibration, see Return to default calibration on page 186.

3.If you would like to fine-tune the calibration or are using a transparent paper, press , then , then Image quality maintenance > Paper advance calibration > Adjust paper advance.

ENWW Recalibrate the paper advance 185