IBM 8304, 8309, 8308, 8312, 8313, 8311, 8310, 8315, 8314, 8301, 8306 Did YOU Receive the Correct RESPONSE?

DID YOU RECEIVE THE CORRECT RESPONSE?

If NO, continue to
002.

If YES, proceed to
003.

002

If the Power Management feature is enabled, do the following:

1.Start the Configuration/Setup Utility program (see “Setup Utility program” on page 24)

2.Select Power Management from the Configuration/Setup Utility program menu.

3.Select APM.

4.Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or Right Arrow (Æ) to change the setting.

5.Select Automatic Hardware Power Management.

6.Set Automatic Hardware Power Management to Disabled.

7.If the problem persists, continue to
003.

003

Run the Diagnostic programs. If necessary, refer to “Diagnostics” on page 26.

vIf you receive an error, replace the part that the diagnostic program calls out or go to ″Symptom-to-FRU Index″ on page 87.

vIf the test stops and you cannot continue, replace the last device tested.

4Hardware Maintenance Manual