IBM 8314, 8309, 8308, 8312, 8313, 8311, 8310, 8315, 8301, 8306, 8304, 8302, 8303, 8305 Installing Options

The following illustration shows the locations of the drive bays.

The following list describes some of the drives that you can install in each bay and their height requirements:

1 Bay 1 - Maximum height: 43.0 mm (1.7 in.)	CD drive or DVD drive (preinstalled in
	some models)
	5.25-inch hard disk drive
2 Bay 2 - Maximum height: 43.0 mm (1.7 in.)	5.25-inch hard disk drive
	3.5-inch hard disk drive (requires a
	mounting bracket)
	CD drive
	DVD drive
3 Bay 3 - Maximum height: 25.8 mm (1.0 in.)	3.5-inch hard disk drive (preinstalled)
4 Bay 4 - Maximum height: 25.8 mm (1.0 in.)	3.5-inch diskette drive (preinstalled)

Notes:

1.Drives that are greater than 43.0 mm (1.7 in.) high cannot be installed.

2.Install removable media (tape or CD) drives in the accessible bay (bay 1 or 2).

Installing a drive: To install an internal drive, follow these steps:

1.Remove the cover. See “Types 8305, 8306, 8309, and 8313” on page 40.

2.If your computer has a CD drive or DVD drive, you might need to remove the signal and power cables from the drive.

3.If the drive you are installing is a removable-media drive, remove the bay panel from the front bezel.

4.Remove the metal shield from the drive bay by inserting a flat-blade screwdriver into one of the slots and gently prying it loose.

5.Pivot the drive-bay latch handle toward the front of the computer and then pivot the drive-bay cage upward, as shown, until it is latched in the upright

Chapter 5. Installing Options 57