IBM 8301, 8309, 8308, 8312, 8313, 8311, 8310, 8315, 8314, 8306, 8304, 8302, 8303 Hardware Maintenance Manual

position.

6.Make sure the drive that you are installing is set correctly as either a master or a slave device.

v If it is a hard disk drive, set it as a slave device.

vIf it is the first CD drive or DVD drive, set it as a master device.

vIf it is an additional CD drive or DVD drive, set it as a slave device.

Refer to the documentation that comes with your drive for master/slave jumper information.

7.Install the drive into the bay. Align the screw holes and insert the two screws.

8.Pivot the drive-bay cage back into place.

9.Each integrated drive electronics (IDE) drive requires two cables; a four-wire power cable that connects to the power supply and a signal cable that connects to the system board.

The steps to connect an IDE drive are different depending on the type of drive you are connecting. Use one of the following procedure for your drive connection.

58Hardware Maintenance Manual