IBM 8306, 8309, 8308, 8312, 8313, 8311, 8310, 8315, 8314, 8301, 8304, 8302, 8303, 8305 Symptom-to-FRU Index

POST Error Code	FRU/Action
1117	1.	Run Enhanced Diagnostics
Failed baud rate test
1162	1.	Run Configuration
Serial port configuration error
	2.	Serial Adapter
		(if installed)
	3.	System Board
11XX	1.	System Board
Not listed above
1201	1.	System Board
	2.	Any Serial Device
1202, 1206, 1208, 1209, 12XX	1.	Dual Async Adapter/A
	2.	System Board
	3.	Any Serial Device
1207	1.	Communications Cable
	2.	Dual Async Adapter/A
13XX	1.	Game Adapter
1402	Information only
Printer not ready
1403	Information only
No paper error, or interrupt failure
1404	1.	Run Enhanced Diagnostics
System board timeout failure
1405	1.	Run Enhanced Diagnostics
Parallel adapter error
1406	1.	Run Enhanced Diagnostics
Presence test error
14XX	1.	Printer
Not listed above. Check printer before
	2.	System Board
replacing system board
15XX	1.	SDLC Adapter
1692	1.	Run FDISK to ensure at least one active
Boot sequence error
		partition is set active
16XX	1.	36/38 Workstation Adapter
1762	1.	Run Configuration. (See “Setup Utility
Hard disk drive configuration error
		program” on page 24.)
1780 (Disk Drive 0)	1.	Hard Disk Drive
1781 (Disk Drive 1)
	2.	System Board
1782 (Disk Drive 2)
	3.	Riser card
1783 (Disk Drive 3)
	4.	Hard Disk Cable
	5.	Power Supply

Chapter 7. Symptom-to-FRU Index 115