IBM 8303, 8309, 8308, 8312, 8313, 8311, 8310, 8315, 8314, 8301, 8306, 8304, 8302 Hardware Maintenance Manual

4.Remove the metal shield from the drive bay by inserting a flat-blade screwdriver into one of the slots and gently prying it loose.

5.Make sure the drive that you are installing is set correctly as either a master or a slave device.

v If it is the first CD drive or DVD drive, set it as a master device.

vIf it is an additional CD drive or DVD drive, set it as a slave device.

vIf it is a hard disk drive, set it as a slave device.

Refer to the documentation that comes with your drive for master/slave jumper information.

6.Install the drive into the bay. Align the screw holes, and insert the screws that secure the drive to the bay.

7.Each integrated drive electronics (IDE) drive requires two cables; a four-wire power cable that connects to the power supply and a signal cable that connects

62Hardware Maintenance Manual