Intel SR1520ML manual Installing and Removing the PCI Riser Assembly

Note: Your server system includes a USB Y-cable attached to the server board. One part of this cable is attached to the front panel board. The other cable is loose. This loose cable is for the Intel® VSSD.

5.Install the server system cover. For instructions, see “Installing the Server System Cover”.

6.Plug all peripheral devices and the AC power cable into the server.

Installing and Removing the PCI Riser Assembly

Caution: The PCI riser assembly is NOT hot swappable. Before removing or replacing the PCI riser assembly, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the system or wall outlet.

Removing the PCI Riser Assembly

To remove the PCI riser assembly, use the following instructions.

1.Observe the safety and ESD precautions at the beginning of this book. See “Safety Information” on page iii.

2.Power down the server and unplug all peripheral devices and the AC power cable.

3.Remove the server system cover. For instructions, see “Removing the Server System Cover” on page 14.

4.Disconnect any cables attached to any add-in cards.

5.Remove the screw from the riser asssembly bracket. See letter “A” in the following figure.

6.Lift up on the riser assembly to remove it. Use caution to gently ease the riser card from the add-in card slot so you do not damage the slot or the riser card. See letter “B” in the figure.

Intel® Server System SR1520ML User’s Guide 21