Intel SR1520ML manual Replacing a Blower Fan, Disconnecting Cables

Replacing a Blower Fan

1.Observe the safety and ESD precautions at the beginning of this book. See “Safety Information” on page iii.

2.Power down the server and unplug all peripheral devices and the AC power cable.

3.Remove the server system cover. For instructions, see “Removing the Server System Cover”.

4.Remove the processor air duct. For instructions, see “Removing the Processor Air Duct” on page 28.

5.The fan cables are tucked underneath the main power supply cable. For ease of access, disconnect the main power supply cable on both server boards. See letter “A” in the following figure.

6.Disconnect the fan cable from each server board. See letter “B” in the figure.

A

B

Figure 32. Disconnecting Cables

7.Remove the five screws that hold the fan bracket in place. Save these screws. You will re-install them later. See letter “A” in the figure below.

8.Lift the fan bracket with the attached fans from the server, working it out from underneath the front panel, USB, and SATA cables. See letter “B” in the figure.

Intel® Server System SR1520ML User’s Guide 41