22 Intel® Server System SR1520ML User’s Guide
Figure 14. Removing PCI Riser Assembly
7. If you need to replace the PCI riser card, see “Removing and Installing the PCI
Riser Card” on page 24.
8. If you need to install or remove a PCI add-in card, see “Installing and Removing a
PCI Add-in Card” on page 26.
9. If you removed the PCI riser assembly as instructed in another procedure, continue
with that procedure.
Installing the PCI Riser Assembly
Note: For clarity, the figure in this series of instructions does not show an attached add-in card.
If you are installing an add-in card, do so before installing the PCI riser assembly into
your server system.
1. Lower the riser assembly into place over the add-in card slot. See letter “A” in the
following figure, aligning the tabs on the riser assembly with the matching slot at
the back of the server system, and aligning the riser card with the slot in the server
board.
2. Press down uniformly until the riser card is seated on the server board.
3. Insert the screw into the riser asssembly bracket. See letter “B” in the figure.
AF002512
A
B