JVC KD-SH1000 manual Jvc

INSTALLATION (IN-DASH MOUNTING)		
The following illustration shows a typical installation. If you have any questions or require information		JVC
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.	

Do the required electrical connections.

*1 When you stand the unit, be careful not to damage the fuse on the rear.

*1

Bend the appropriate tabs to hold the sleeve firmly in place.

*2 Fit the protrusions outside the unit.

*2

Removing the unit

Before removing the unit, release the rear section.

Insert the two handles, then pull them as illustrated so that the unit can be removed.

When using the optional stay /

When installing the unit without using the sleeve /

In a Toyota car for example, first remove the car radio and install the unit in its place.

Fire wall	Stay (option)
		

Dashboard

Screw (option)



(TOYOTA) 

Flat type screws (M5 × 8 mm)*3 (M5 × 8 mm)*3

Bracket*3

*3

Pocket

Bracket*3

*3

*3 Not supplied for this unit.

*3

Flat type screws (M5 × 8 mm)*3 (M5 × 8 mm)*3

Install the unit at an angle of less than 30˚. 30˚

Note	: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
	:	used, they could damage the unit.
		8 mm

Caution when installing /

Fit the unit into the mounting sleeve by using four corners of the trim plate.

• DO NOT press the panel (shaded in the illustration).

•

2