JVC KD-SH1000 Connecting the external amplifiers and/or subwoofer, Power cannot be turned on

ENGLISH

B	Connecting the external amplifiers and/or subwoofer /	/
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it •				
can be controlled through this unit.

•For amplifier only:

–Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.

–You can switch off the built-in amplifier and send the audio signals only to the external amplifier(s) to get clear sounds and to prevent internal heat built-up inside the unit (see page 21 of the INSTRUCTIONS).

–The line output level of this unit is kept high to maintain the hi-fi sounds reproduced from this unit. When connecting an external amplifier to this unit, turn down the gain control on the external amplifier to obtain the best performance from this unit.

•!

–

–

21

–

 

Remote lead

Remote lead (Blue with white stripe)



Y-connector (not supplied for this unit)

Y-  

To the remote lead of other equipment or auto antenna if any



Rear speakers

JVC Amplifier

JVC

Front speakers

JVC Amplifier

JVC

JVC Amplifier Subwoofer

JVC

Front speakers

*1 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

*1  

*2 Signal cord (not supplied for this unit)

*2  

TROUBLESHOOTING

• The fuse blows.	•
* Are the red and black leads connected correctly?	*				%
• Power cannot be turned on.	•
* Is the yellow lead connected?	*		%
• No sound from the speakers.	•
* Is the speaker output lead short-circuited?	*			%
• Sound is distorted.	•
* Is the speaker output lead grounded?	*			%
* Are the “–” terminals of L and R speakers grounded in common?	*	(L)	(R)	(–)	%
• Noise interfere with sounds.	•
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?	*				%
• This unit becomes hot.	•
* Is the speaker output lead grounded?	*			%
* Are the “–” terminals of L and R speakers grounded in common?	*	(L)	(R)	(–)	%
• This unit does not work at all.	•
* Have you reset your unit?	*		%
	4