JVC KD-SH1000 manual ~ Enter the SEL menu see Select a setting item, Fad fader, Bal balance

Activating crossover network

By activating crossover network, you can allocate different frequency range of sound signals to different speakers to match their characteristic.

If you have installed the 3-way network speaker system in the car, make sure of the following:

•Before using the system, activate crossover network and preset the appropriate cutoff frequencies for HPF/LPF (especially

for HPF); otherwise, it may damage the speakers.

•For 3-way network speaker system, see Installation/Connection Manual (separate volume).

You cannot perform other operations until you finish the following procedure.

While the power is turned off...

~

Ÿ

!

•To cancel the procedure, press and hold POWER/ATT/ENTER. The power turns off.

⁄Finish the procedure.

• indicator lights up (in sequence with other indicators).

To cancel Crossover, repeat the same procedure. Make sure that “X-Over Off OK?” appears on the display.

• indicator goes off.

Setting the sound modes—SEL

You can adjust the sound characteristics to your preference.

~Enter the SEL menu (see page 4).

ŸSelect a setting item.

*Appears only when crossover network is activated (see left column).

When selecting “Fad/Bal,” “X-Over,” or “S.woofer,” press POWER/ATT/ENTER to enter its submenu.

!Adjust the selected setting item. (See the following for details.)

•To adjust other SEL settings, press BACK. Then repeat steps Ÿ and !.

⁄Finish the procedure.

To adjust fader and balance—Fad/Bal

•Fad (fader)

Adjust the front and rear speaker balance.

•Bal (balance)

Adjust the left and right speaker balance.

ENGLISH

21