JVC KD-SH1000 manual To adjust subwoofer output- S.woofer

To adjust reproduced frequency level—X-Over

This setting is available only when crossover network (see page 18) is activated.

1Select a filter.

HPF : Frequencies lower than the (Front/Rear) selected level are cut-off.

LPF (Rear) : Frequencies higher than the selected level are cut-off.

2Select “On” to activate the selected filter.

•If you connect high-range speakers to Front or Rear output, select “On” for the corresponding HPF to prevent the speakers from being damaged.

To adjust subwoofer output— S.woofer

1Adjust the output level.

2Select a cut-off frequency according to the connected subwoofer.

3Adjust the continuity of the sound among speakers (slope).

ENGLISH

3Select a cut-off frequency according to the connected speakers.

1.6kHz – 16.0kHz : Front HPF and Rear LPF

31.5 Hz – 200.0Hz : Rear HPF

4Adjust the continuity of the sound among speakers (slope).

To adjust the input level of each source—Vol Adj

This setting is required for each source except for FM.

Once an adjustment is made, it will be memorized. When you change the source the volume level will automatically increase or decrease according to the adjusted level.

1Select a source before entering the SEL menu.

2Adjust to match the input level to the FM sound level.

19