JVC KD-SH1000 Installation IN-DASH Mounting, When using the optional stay / ‡¡ËՄȵ«¬÷- ¥·‡≈Õ‰¥È

INSTALLATION (IN-DASH MOUNTING)

The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.

• If you are not sure how to install this unit correctly, have it installed by a qualified technician.

°“√µ‘¥µßÈ— (°“√ª√–°Õ∫·ºßÀπÈ“ª∑¡Ï‡— ¢È“)

¿“浫լ˓ߵËÕ‰ªπ’È·— ¥ß∂÷ß°“√µ‘¥µß·∫∫∑È—«‰ªË— À“°§ÿ≥¡’ª≠À“À√◊ÕµÈÕß°“√—¢ÈÕ¡Ÿ≈‡°’ˬ«°—∫™ÿ¥µ‘¥µ—Èß °√ÿ≥“ª√÷°…“°∫ºŸÈ— ¢“¬‡§√◊ËÕ߇ ’ ¬ß√∂¬πµÏJVC ¢Õß∑Ë“πÀ√◊Õ∫√‘…—

•™ÿ¥ª√–°Õ∫ ∂È“§ÿ≥‰¡Ë·πË„®«Ë“µ‘¥µß™ÿÈ— ¥ª√–°Õ∫π’È∂Ÿ°µÈÕßÀ√◊Õ‰¡Ë„ÀÈÀ“™Ë“ߺŸÈ‡™’ˬ«™“≠‡ªÁπºŸÈµ‘¥µßÈ—

Do the required electrical connections.

µËÕ “¬‰øµ“¡∑’Ë°”À𥉫È∑ßÀ¡È— ¥

Bend the appropriate tabs to hold the sleeve firmly in place.

ßÕ·ºËπ‡æ◊ËÕ¬÷¥ª≈Õ°„ÀȵËÕ°π‡— ¢È“∑’Ë

*1 When you stand the unit, be careful not to damage the fuse on the rear.

*1 ‡¡◊ËÕ§ÿ≥µß™ÿ—È ¥ª√–°Õ∫¢÷Èπ √–«ßլ˓∑”„ÀÈø‘«— Ï∫√‘‡«≥ Ë«π∑È“¬‡ ’¬À“¬

*2 Fit the protrusions outside the unit.

*2 µ‘¥µß≈Ë«π∑’ˬ◊ËπÕÕ°¡“∑’˗ȥȓππÕ°‡§√◊ËÕß

Removing the unit

Before removing the unit, release the rear section.

°“√∂Õ¥™ÿ¥ª√–°Õ∫

°ËÕπ®–∂Õ¥™ÿ¥ª√–°Õ∫ „ÀȪ≈¥ÀπÈ“µ¥— «π∑È“¬°ËÕπË

Insert the two handles, then pull them as illustrated so that the unit can be removed.

„ §Ë π∫— ߧ— ∫— 2 Õπ≈ß„π√ËÕß— ”À√∫„™Èæ—π≈«— ¥

¥ß¿“æ— ®“°ππÈ— „Àȇ≈◊ËÕπ™ÿ¥ª√–°Õ∫ÕÕ° „π¢≥–

∑’˧ËÕ¬ Ê ¥÷ߧπ∫—ߧ—∫∑—ßÈ— Õß ÕπÕÕ°®“°°—π—

When using the optional stay / ‡¡◊ËÕ„™Èµ«¬÷— ¥·∫∫‡≈◊Õ°‰¥È

Fire wall	Stay (option)
ºπß°—π‰ø—	µ«¬÷— ¥ (‡≈◊Õ°‰¥È)

When installing the unit without using the sleeve / ‡¡◊ËÕµ‘¥µß™ÿÈ— ¥ª√–°Õ∫‚¥¬‰¡Ë„™Èª≈Õ°ÀÿÈ¡

In a Toyota car for example, first remove the car radio and install the unit in its place.

µ«Õ¬Ë“߇™Ëπ— „π√∂¬πµÏ‚µ‚¬µÈ“ „ÀÈ∂Õ¥«‘∑¬ÿµ‘¥√∂¬πµÏÕÕ°°ËÕπ ·≈ô«®÷ßµ‘¥µíô߇§√◊ËÕßπ’ô‡¢ô“·∑π∑’Ë

Dashboard

·ºßÀπÈ“ª∑¡á—

Screw (option)

°√Ÿ(‡≈◊Õ°‰¥È)

Flat type screws (M5 × 8 mm)*3

°√ŸÀ«‡√’¬∫— (M5 ⋅ 8 ¡¡.)*3

Bracket*3

·∑Ëπ√Õß√∫—*3

Pocket

°–‡ª“–Bracket*3

·∑Ëπ√Õß√∫—*3

*3 Not supplied for this unit.

*3 ‰¡Ë‰¥È„ÀÈ¡“°∫™ÿ— ¥ª√–°Õ∫π’È

Flat type screws (M5 × 8 mm)*3

°√ŸÀ«‡√’¬∫— (M5 ⋅ 8 ¡¡.)*3

Install the unit at an angle of less than 30˚.

µ‘¥µß™ÿ—È ¥ª√–°Õ∫∑’Ë¡ÿ¡µË”°«Ë“ 30˚ Õß»“

Note	: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
	used, they could damage the unit.
À¡“¬‡Àµ	: ‡¡◊ËÕµ‘¥µß™ÿÈ— ¥ª√–°Õ∫≈ß„π·∑Ëπ√Õß√∫‰«È—„ÀÈ„™È °√Ÿ¬“«¢π“¥ 8 ¡¡. ∂È“„™È °√Ÿ¬“«°«Ë“π’ÈÕ“®∑”„ÀÈ™ÿ¥ª√–°Õ∫‡ ¬À“¬‰’	¥ô

Caution when installing / ¢ÈÕ§«√√–«ß‡¡◊ËÕ∑”°“√µ‘—¥µßÈ—

Fit the unit into the mounting sleeve by using four corners of the trim plate.

• DO NOT press the panel (shaded in the illustration).

µ‘¥µß‡§√◊ËÕ߇ȗ ¢È“„πª≈Õ°ÀÿÈ¡ „Àȵ√ß°∫— ¢Õ∫¢Õß ·ºËπ∑’˵¥— ·µËß∑ßÈ— Ë’

• ÀÈ“¡¥—π∑’Ë·ºß§«∫§ÿ¡ ( Ë«π∑’Ë√–∫“¬ ’„π√Ÿª)

2