Korg D3200 owner manual 104, 2c-3. Event List

5.Mode

When you click this button, the Event Rec Mode dialog box will appear, allowing you to select the automation recording method. Click the OK button (or press the panel YES key) to apply your selection, or click the Can- cel button (or press the panel NO key) to cancel it.

5a

5b

5a. Recording mode

Overwrite: Automation data will be overwritten from the point you begin playing/recording the song until the point where you stop. If you do not record events, all the previously-recorded events will be erased.

Punch Write: Parameters you adjust between the In Time (the location where you begin recording events) and Out Time (the location where you stop) will be recorded.

5b. In Time, Out Time

If the recording mode is “Punch Write” and you selected a parameter other than Fader as the parame- ter to be recorded, these settings specify the locations at which event recording will begin and end.

6.SnapShot

Clicking this button when “4. Automation” is on and the recorder is stopped will record a “snapshot” of events for channels whose record channel button is set to (Rec).

7.Undo

Click this if you want to revert the recorded automation to its prior state. You can revert to the state prior to the previous operation. If the button indicates Redo, you can use it to cancel the Undo.

You can use “2c-3. Event List” to make detailed changes to the recorded events.

This data is held in common with the “8. Undo” data of “2c-3. Event List.” If you press the Event List’s Undo button imme- diately after recording automation, not the most recent event edit but the previously-recorded automation will be erased.

8.Free event memory amount

This indicates the amount of remaining memory in which you can record events.

2c-3. Event List

Here you can view or edit the events and scenes that you re- corded using automation.

2			1
	4
				5
		6
3		7
		8
		9

1.Set View

Click this button to open the Set View dialog box. Click the OK button (or press the panel YES key) to apply your selections, or click the Cancel button (or press the panel NO key) to cancel them.

1a

1b

1a. Event View Source

Click a radio button to choose the parameter that will appear in the event view.

1b. Time Resolution/dot [0.05, 0.1, 0.2, 0.5, 1sec]

Specify the range that will appear in the event view. The range shown will be the time you specify here

×192.

2.Event view

This area shows the events of the source you selected in Set View.

3.Event list

Displays the events selected in the “9. Select List.” To edit an event, select (highlight) it by clicking it in the list.

4.Edit

Click this button to open the Edit Event dialog box.

4a

4b

4a. Event select button

Use this to select the event you want to edit. Click this button and use the value dial (or +/– keys) to make your choice.

104