A4-1. WAVE

A4-2. WAVE

You can click these buttons to view the waveform of the track audio.

This allows you to set the editing locations (IN, OUT, TO, END) more accurately.

Click the A4-1 button if you want to edit IN and OUT, or click the A4-2 button if you want to edit TO and END.

You will find it convenient to set IN (LOC 1), OUT (LOC 2), TO (LOC 3), and END (LOC 4) to their approximate locations before you use this function.

A5. Mode

When you click this button, the Copy Mode dialog box will appear. Select the desired mode and click the OK button (or press the panel YES key).

OverWrite:

Track data previously at the copy-destination will be overwritten.

Insert:

The copied data will be inserted, and subsequent track data will be shifted toward the end of the song.

Wave dialog box

To open this dialog box, click the Source WAVE button if you are setting the “Source” region, or click the Destina- tion WAVE button if you are setting the “Destination” region.

5a

[FF] plays approximately two seconds from the lo- cation (“Play From”)

[STOP] stops playback

[PLAY] plays the location (from In to Out) [REC] plays as a loop

5c. Search Zero

You can click this button and turn the value dial to move to the next or previous zero-cross point.

A “zero cross” point is a point where the waveform level crosses the ±0 amplitude (the center line in the waveform window).

5d. Waveform window

This displays the waveform of the selected track.

You can move the location by clicking in the waveform window and then moving the ClickPoint to left or right while holding down the panel JUMP key. You can also move the location by clicking and holding in the waveform window and then moving the ClickPoint to left or right.

5e. Locate

Click the radio buttons to select the location (IN, OUT, TO, END) you want to edit, and turn the value dial to set the location while you listen to the track audio (soloed). The current location is shown by the vertical bar in the waveform window.

5f. ZOOM

Use these buttons to adjust the size of the waveform display and the playback speed.

vertically expands the waveform display. vertically shrinks the waveform display. horizontally expands the waveform display.

5b

5d

5e

5f

5c

horizontally shrinks the waveform display.

When you click the OK button (or press the panel YES key), the locations you specified will be overwritten to the corresponding key (LOC 1/IN, LOC 2/OUT, LOC 3/ TO, LOC 4/END). If you click the Cancel button (or press the panel NO key), your changes will be discarded.

You can control the ZOOM buttons by holding down the pan- el JUMP key and pressing the cursor keys.

5a. Track selection

Click the popup button, click a radio button in the Select Track dialog box to select the track whose loca- tion you want to specify, and click the OK button (or press the panel YES key).

If you click (highlight) the Stereo button, the wave- forms of two adjacent channels will be displayed in the upper and lower parts of the waveform window.

5b. Preview playback buttons

You can also use the top panel transport keys listed here in square brackets [ ] to operate these controls.

[REW] plays approximately two seconds ending at the location (“Play To”)

128

Page 138
Image 138
Korg D3200 owner manual 128, Wave dialog box