Korg D3200 owner manual 161

Reso HiCut (Resonance High Cut)	53Hz...20.0kHz, THRU
Sets the resonance damping amount in the high range
Type	Blue, U-VB
	Selects the type of phaser
Waveform (LFO Waveform)	Triangle, Sine
	Selects LFO Waveform

40: Mono Tremolo

*Speed (LFO Speed)	0.02...20.00Hz
	Sets the LFO speed
*Depth	0...100
	Sets the depth of LFO modulation
Waveform (LFO Waveform)
	Triangle, Sine, Square, Saw up, Saw down
	Selects LFO Waveform
Dry:Wet	Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
LFO Shape	–100...+100%

Determines how much the LFO waveform is changed

41:Mn.Pitch Shifter (Mono Pitch Shifter)

PitchShift	–24...+24/2tone
Sets the pitch shift amount in steps of a semitone
Fine	–100...+100cent
Sets the pitch shift amount in steps of one cent
Lo/Hi Cut (Low/High Cut)	Lo:-50%..., Flat, ...Hi:-50%
Sets the damping amount in the low/high range
Dry:Wet	Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Feedback	–100...+100%
	Sets the feedback amount
In Level (Input Level)	0...100%
	Sets the input level to the effect

Category: Dynamics&Filter

Dynamics/Filter-type effects

42: Mono Compressor

Threshold	–30.0...0.0dB
Sets the level at which compression begins to apply
Ratio	1.00:1...20.0:1
Sets the compression ration of the signal
Attack	0...1.00sec
	Sets the attack time
Release	0...10.0sec
	Sets the release time
Response	Slow, Medium, Fast
	Selects the response speed
Tube Sat (Tube Saturation)	0...100
Sets the depth of vacuum tube distortion
Out Gain (Output Gain)	–24.0...+24.0dB
	Adjusts the output level gain

43: Mono Expander

Threshold	–48.0...0.0dB
Sets the level at which compression begins to apply
Ratio	1.00:1...20.0:1
	Sets the compression ration of the signal
Attack	0...1.00sec
	Sets the attack time
Release	0...10.0sec
	Sets the release time
Response	Slow, Medium, Fast
	Selects the response speed
Out Gain (Output Gain)	–24.0...+24.0dB
	Adjusts the output level gain

44: Mono Limiter

Threshold	–48.0...0.0dB
Sets the level at which compression begins to apply
Attack	0...1.00sec
	Sets the attack time
Release	0...10.0sec
	Sets the release time
Out Gain (Output Gain)	–24.0...+24.0dB
	Adjusts the output level gain
Response	Slow, Medium, Fast
	Selects the response speed
Tube Sat (Tube Saturation)	0...100
Sets the depth of vacuum tube distortion

45: Mono Gate

Threshold	–48.0...0.0dB
Adjusts the level at which compression
Attack	0...1.00sec
	Sets the attack time
Release	0...10.0sec
	Sets the release time
Range	–inf, –48...0.0dB
	Compression level
Response	Slow, Medium, Fast
	Selects the response speed
PreDelay (Pre Delay Time)	0...200ms
	Sets the delay time
Out Gain (Output Gain)	–24.0...+24.0dB
	Adjusts the output level gain

46: Mono Filter

Fc Bottom (Control Fc Bottom)	53Hz...20.0kHz
Sets the lower limit of the frequency to be controlled
Fc Top (Control Fc Top)	53Hz...20.0kHz
Sets the upper limit of the frequency to be controlled
Resonance	0...100%
	Sets the resonance amount
Trim	0...100%
	Adjusts the filter level
FilterType	HPF, BPF, LPF
	Selects the filter type
Control (Control Source)	Envelope, LFO
	Switches the control source
Polarity	[+]Plus, [–]Minus
	Inverts the control

Algorithm list
Program list
Stereo type	Algorithm
Monaural type	Algorithm

Effect

161