You can select how the PAN will operate when channels are paired.

(1)Access the MIXER, PAIR/GROUP , “Ch Pair” tab page.

(2)In Select Pair Ch, select the channels that you want to pair.

Click one of the “1 2”“31 32” buttons to change the symbol to “ ”.

If you want to disable pairing, click the paired button to change the symbol to “ ”.

(2)

(3)

(3)Click the Pan Mode radio buttons to select how the PAN knob will operate for paired channels (p.102).

3-6. Group settings

Multiple channels can be assigned to a “Group”. Operating the fader of any channel assigned to that group will adjust the volume of all channels in the group while maintaining their relative volume balance.

In addition, each channel can also be assigned to a CH ON group. When the on/off status of any channel in that CH ON group is changed, the status of all other channels in that group will also change.

Fader groups

(1)Access the MIXER, PAIR/GROUP, “FaderGroup” tab page.

(2)Click the radio buttons to select a group (A–D) for each channel fader.

(3)Click the Fader Group On buttons A–D to enable the desired groups.

You may enable more than one group.

(2)

(3)

CH ON groups

(1)Access the MIXER, PAIR/GROUP, “ChOnGroup” tab page.

(2)Use the radio buttons to select a group (E–H) for each channel.

(3)Click the Ch On Group On buttons E–H to enable the desired groups.

You may enable more than one group.

(2)

(3)

3-7. Monitor settings

Here’s how to select the audio signal that will be output from MONITOR and PHONES.

(1)Connect your monitor system.

You can either connect amplified speakers or a similar system to the MONITOR L/R jacks, or connect head- phones to the PHONES jack.

(2)Select the monitor source.

Access the MIXER, SOLO/MONITOR, “Monitor” tab page, and click the source that you want to monitor.

Master LR

Monitor the audio of the master bus.

Solo

Monitor the audio that is being soloed.

When you adjust the settings in the “Solo” tab page, the monitor source will be selected automatically.

If you want to defeat this, you can do so in the “Solo” tab page (p.48 “3-9. Solo settings”).

Cue

Monitor the volume and pan as set in the cue mix, inde- pendent of the channel faders and PAN knobs (p.48 “3-8. Adjusting the cue level”).

Drums

If this is on, the drum pattern sound will be output only from the monitor bus. In this case, the SESSION DRUMS, “DrmsMixer” tab page Assign setting will be set to “Monitor.” This is convenient when you want to monitor only the rhythm, such as during a live perform- ance.

 

Song,

Locate

 

 

 

 

 

 

 

Mixer

 

 

 

 

 

Effects

 

 

 

 

Session

Drums™

 

 

 

Recorder

 

 

 

 

 

 

 

 

 

 

 

Operation

 

 

 

 

 

CD

 

 

 

 

Data

 

 

 

 

 

 

Drive

 

 

 

 

 

 

USB

 

 

 

 

 

 

MIDI

 

 

 

 

 

 

Upgrading

the system

 

 

 

Recovery

CD

 

 

ClickPoint

calibration

 

 

 

 

 

47

Page 57
Image 57
Korg D3200 owner manual Group settings, Monitor settings, Fader groups, CH on groups