Korg D3200 About the CD-R/RW drive

12
8 S/P DIF IN jack
This is an optical-type S/P DIF format (IEC60958, EIAJ CP-1201) digital input jack (stereo).
Use an optical cable to connect this jack to the optical digital output of your DAT, MD or other equip-
ment.
This input provides a digital audio signal at the same sampling frequency and bit depth as the current
song.
9 USB connector
You can use a USB cable to connect the D3200 to your computer.
USB peripheral devices such as external hard disks and CD-R/RW drives cannot be connected to the D3200.
About the CD-R/RW drive
The D3200’s front panel contains a CD-R/RW drive that you can use to backup and restore data, im-
port and export WAV audio files, and to play or write audio CDs.
The disc drive is a precision device; always use it in a horizontal position that is not subject to vibration.
Inserting a disc
Make sure that the D3200 is on.
(1)Press the eject button of the CD-R/RW drive to open the disc tray.
(2)Place the disc accurately in the tray, label side up.
(3)Press the eject button to close the CD-R/RW drive.
Removing a disc
(1)Press the eject button to open the disc tray.
(2)Gently remove the disc from the disc tray.
(3)Press the eject button to close the CD-R/RW drive.
Emergency disc removal
Normally you will be able to remove the disc as described above. However, if this is not possible due
to a power failure or other problem, you can also remove the disc as follows.
Insert a pin-like object of less than 1 mm diameter, such as a straightened paper clip, into the manual
eject pinhole and push. The disc tray will be forced open.
Excessive use of this method may cause the disc drives to malfunction.
This procedure must be performed with the power off.
Eject buttonManual eject pinhole