Kyocera FS-1100, FS-C5400DN, FS-1300D manual Printed Results, Corrective Action, Replacement on page

Printed Results	Corrective Action
Black or white vertical streaks	Check the operation panel for toner.
	If the Toner is running out. message is displayed, install a new
	toner kit. To replace the toner container, refer to Toner Container
	Replacement on page 5-2.
	Clean the LSU.
	For details, refer to LSU (LSU cleaning mode setting) on page 4-109.
	Refresh drum.
Direction
of Paper	Perform the following procedures on the operation panel and try cleaning
Feed	the drum surface using the printer's built-in cleaning system.
	1	In the mode selection menu, press [U] or [V] to select Adjust/
		Maint..
	2	Press [OK]. Adjust/Maint. menu screen appears.
	3	Press [U] or [V] to select Service Setting.
	4	Press [OK]. The Service Setting menu screen appears.
	5	Press [U] or [V] to select Drum.
	6	Press [OK]. A drum cleaning confirmation message is displayed.
	7	Press [Yes] ([Left Select]). Drum cleaning begins. When drum
		cleaning ends, the Service Setting menu reappears.
Faint or blurred printing	Refresh drum.
	For details, refer to Drum (Drum/Refresh mode setting) on page 4-109.
	Make sure the paper type setting is correct the paper being used.
	For details, refer to Paper Settings on page 4-33.
	Conduct color calibration either by switching the printer off then on or using
	the printer operation panel.
	For details, refer to ColorCalibration on page 4-97.
	Try adjusting the color control settings using the printer driver.
	Check the operation panel. If the Toner is running out. message
	is displayed, install a new toner kit. To replace toner, refer to Toner
	Container Replacement on page 5-2.

6-4 Troubleshooting