Kyocera FS-1300D, FS-C5400DN manual Err. Clear Timer: a b, Sleep Timer Sleep timer timeout time

Err. Clear Timer: a b

(5 - 495) /**30-sec.

M

Sleep Timer: a b

(1 - 240) /45-min.

M

Err. Clear Timer (Setting the error clear time)

If Auto Err. Clear is set to On and a non-fatal error (an error that allows printing to continue) occurs, this setting specifies the time until the error is recovered and printing resumes. The default setting is 30 seconds.

1In the Timer Setting menu, press U or V to select Err. Clear Timer.

2Press [OK]. The Err. Clear Timer screen appears.

3Use the arrow keys to set the recovery time.

Press U or V to increase or decrease, respectively, the value at the blinking cursor.

Use Y and Z to move the cursor right and left.

4Press [OK]. The recovery time setting is stored and the Timer Setting menu reappears.

Sleep Timer (Sleep timer timeout time)

If Auto Sleep is set to On, you can adjust the length of time the printer waits before entering Auto Sleep in the absence of data. The printer reverts to normal operation mode when the printer receives a print job, [OK] is pressed or one of the exterior covers is opened. The default time is 45 minutes.

Note Color calibration is automatically executed before the printer reverts to normal operation mode.

1In the Timer Setting menu, press U or V to select Sleep Timer.

2Press [OK]. The Sleep Timer screen appears.

3Use the arrow keys to set the sleep time.

Press U or V to increase or decrease, respectively, the value at the blinking cursor.

Use Y and Z to move the cursor right and left.

4Press [OK]. The sleep time setting is stored and the Timer Setting menu reappears.

4-72 Using the Operation Panel