OPTIONS/ACCESSORIES
The following options/accessories are available for your Commander 500 from your local Lincoln Distributor.
FIELD INSTALLED OPTIONS
K802N POWER PLUG KIT - Provides a plug for each receptacle.
K857 25 ft. (8.5 m) or K857-1 100 ft. (30.4 m) REMOTE CONTROL - Portable control provides same dial range as the output control on the welder from a location up to the specified length from the welder. Has convenient plug for easy connection to the welder. The Commander 500 is equipped with a 6-pin connector for connecting the remote control.
K704 ACCESSORY SET - Includes 35 feet (10 m) of electrode cable and 30 feet (9 m) of work cable, head- shield, work clamp and electrode holder. Cable is rated at 500 amps, 60% duty cycle.
K953-1 TWO-WHEEL TRAILER - For road, in-plant and yard towing. Road towing with optional fender and light kit. (For highway use, consult applicable federal, state and local laws regarding possible additional requirements.)
•K953-1 Trailer
•K958-1 Ball Hitch
•K958-2 Lunette Eye Hitch
•K959-1 Fender and Light Kit
•K965-1 Cable Storage Rack
K825-1 ETHER START KIT - Provides maximum cold weather starting assistance for frequent starting below 10° F (-12.2° C). Required Ether tank is not provided with kit.
K949-1 OIL DRAIN KIT - Includes ball valve, hose and clamp.
K1690-1 (1 DUPLEX) GFCI KIt - Includes a UL approved 115 volt ground fault circuit interrupter recep- tacle (duplex type) with cover and installation instruc- tions. Each half of the receptacle is rated 15 amps, but the maximum total current from the GFCI duplex is lim- ited to 20 amps. The GFCI receptacle replaces the fac- tory installed 115 volt duplex receptacle. Two kits are required.
K899-1 SPARK ARRESTER KIT - Easily mounts to standard muffler.
K1816-1 FULL KVA ADAPTER KIT - Plugs into the 120/240V NEMA 14-50R receptacle on the case front (which accepts 4-prong plugs) and converts it to a NEMA 6-50R receptacle (which accepts 3-prong plugs).
K1768-1 DUAL OUTPUT METERS AND GAUGES - Dual output meters provide preset ability of voltage for wire welding and current for stick welding. Measures both current and voltage when welding. Gauges include battery ammeter, engine temperature, and engine oil pressure. Fuel gauge is not available in kit form.
STICK WELDING ACCESSORIES
K704 Accessory Kit, which includes:
•Electrode holder and cable.
•Ground clamp and cable.
•Headshield.
K857 Remote Control Kit is optional for remote cur- rent control.
TIG WELDING ACCESSORIES
•Magnum TIG Torch
•Magnum Parts Kit and Argon gas
•K930-ALL TIG Module (not required for scratch-start DC TIG welding)
•K936-1 Control Cable
•K870 Foot Amptrol
Also available:
•K963-1/-2 Hand Amptrol
•K814 Arc Start Switch
•K937-22 Control Cable Extension
•K937-45 Control Cable Extension
•K844-1 Water Valve
