Lincoln Electric SVM153-A Procedure, Control Panel Removal Screws Front Green Ground Lead

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

F-62	F-62
	TROUBLESHOOTING & REPAIR

POWER MODULE/OUTPUT RECTIFIER BRIDGE ASSEMBLY

REMOVAL AND REPLACEMENT (CONTINUED)

F.27 – CONTROL PANEL REMOVAL

SCREWS

FRONT

CONTROL

PANEL

SCREW

GREEN

GROUND

LEAD

Return to Section TOC

Return to Master TOC

PROCEDURE

1.Turn the engine off.

2.Using the 3/8" wrench, remove the screws holding the front control panel to the case top and sides. See Figure F.27. (There are two screws on the top and one screw on each side.)

3.Carefully lower the front control panel.

4.Using the 3/8" wrench, remove the front left and right side panels.

5.Perform the Output Panel Removal section of the Case Cover Removal procedure.

6.Perform the Power Module Capacitor

Discharge Procedure.

7.Optional: With the 7/16" wrench, remove the ground wire from the output panel assembly. If the ground wire is not in the way, it can remain attached.

COMMANDER 500