Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| TROUBLESHOOTING & REPAIR |
| |
| TROUBLESHOOTING GUIDE | Observe Safety Guidelines | |
|
| detailed in the beginning of this manual. | |
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED | |
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION | |
|
|
|
|
| WELDING PROBLEMS |
|
|
Poor arc striking when using semi- | 1. Make sure the correct weld pro- | 1. | Check reed switch CR3 for |
automatic or automatic wire | cedures are being used. |
| proper operation. Switch |
feeders. | (Electrode, Gas, Etc.) |
| should be normally open until |
| 2. Check the welding cables for |
| weld current is established. |
|
|
| |
| loose or faulty connections. | 2. | The start board may be faulty. |
|
|
| Replace. |
|
| 3. | The control board may be |
|
|
| faulty. Replace. |
|
|
|
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
IDEALARC
LINCOLN ®
ELECTRIC
