Basic Safety Precautions for Installation and Use
Always follow these basic safety precautions when installing or using this product to reduce risk of injury from fire or electric shock.
!
WARNING:
Installation of this equipment for
!
CAUTION:
This equipment is for installation on Lucent Technologies PARTNER, PARTNER Plus, PARTNER II, MERLIN, MERLIN Plus, MERLIN II, MERLIN LEGEND, System 25, System 75, System 85, and DEFINITY communications systems only.
■
■
■
Read and understand all instructions in this book before using this product.
Observe all warnings and instructions marked on the product.
Do not use the product near water or when you are wet. If the product comes in contact with any liquids, unplug the power cord and telephone line cords immediately. Do not plug the product back in until it has dried thoroughly.
■Never push objects of any kind into this product through housing slots, since the objects may touch hazardous voltage points or short out parts that could result in a risk of electric shock. Never spill liquid of any kind on the phone.
■If you suspect a gas leak, report it immediately, but use a phone away from the area in question. The phone’s electrical contacts could generate a tiny spark. While unlikely, it is possible that this spark could ignite a heavy concentration of gas. This product is not approved for use in areas labeled by the Occupational Safety and Health Administration (OSHA) as “explosive environments.” Only “Explosive Atmosphere Telephones” may be used in such hazardous environments.
■Unplug this product from wall outlets and telephone jacks before cleaning. Clean exposed parts with a soft, damp cloth. Do not use liquid or aerosol cleaners.
■Unplug this product from the wall outlet, remove the telephone line cord from the modular wall jack or communications system switch/control unit, and refer servicing to qualified service personnel under the following conditions:
–When the power cord or plug is damaged or frayed.
–If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.
–If the product has been dropped and the housing has been damaged.
■This product should be serviced by (or taken to) a qualified service center when service or repair work is required. Do not open the product, there are no
■Always unplug the power cord/AC adapter for the carrier or carriers from the wall outlet when:
–Removing a radio module
–Moving a radio module to a new slot in the carrier
