Lucent Technologies Transtalk 9000 manual Display Messages, Line Status Indicators

Display Messages

The top line of the handset display uses up to 16 alphanumeric characters to provide messages such as the following:

■LCL:P (or LCL:D, LCL:M1, or LCL:M2) indicates that the handset is in Local Mode, and tells which communications system the button mapping is set to emulate:

LCL:P PARTNER systems

LCL:D DEFINITY systems, System 25, System 75, and System 85

LCL:M1 All MERLIN systems (except MERLIN 410 and MERLIN 820), including MERLIN LEGEND

LCL:M2 MERLIN 410 and MERLIN 820

■WIRELESS TEST indicates that the handset is in Wireless Test Mode; 1 through 10 are used to measure signal strength and voice quality in Wireless Test Mode.

■VIBR indicates that the vibrator is enabled to notify you of incoming calls.

■PSEL indicates that Line Preselection is enabled.

■PRESELECTION:ON or PRESELECTION:OFF is displayed when you enter Preselec- tion Mode, and indicates the status of the Line Preselection option.

■CHANGE BUTTN MAP is an error message indicating that the handset is set for the wrong communications system. See "Changing the Communications System Setting" in Chapter 2 for instructions for changing the setting.

■MAP:P (or MAP:D, MAP:M1, or MAP:M2) is displayed when you enter Button Mapping Mode, and indicates the communications system to which the MDW 9030P buttons are currently mapped:

MAP:P PARTNER systems

MAP:D DEFINITY systems, System 25, System 75, and System 85

MAP:M1 All MERLIN systems (except MERLIN 410 and MERLIN 820), including MERLIN LEGEND

MAP:M2 MERLIN 410 and MERLIN 820

■NO LINK is an error message indicating that the handset is not communicating with its radio module. See Chapter 5, "Troubleshooting," for help in resolving this problem.

Line Status Indicators

There are 12 status indicators; each one corresponds to a specific outside line or program- mable/intercom/drop button. (The function of these status indicators varies, depending on the communications system you are using—see button mapping for the appropriate communications system switch in Chapter 6, "MDW 9030P Pocketphone Compatibility.") The status indicators show either a truncated triangle or a rectangle, signifying activity as follows:

PARTNER Systems:

A rectangle (

) is the equivalent of a red LED on a wired system phone.

A truncated triangle () is the equivalent of a green LED on a wired system phone.

All Other Systems:

A rectangle (

) is the equivalent of a green LED on a wired system phone.

A truncated triangle () is the equivalent of a red LED on a wired system phone.

Using the MDW 9030P Pocketphone 3-5