Changing the Communications System Setting
The communications system you use determines what information the MDW 9030P Pocket- phone can display and how the phone lines and programmable/intercom/drop buttons are identified (see "Button Mapping" in Chapter 6, "MDW 9030P Pocketphone Compatibility").
The MDW 9030P is
To change the communications system setting, use the following procedure to enter Local Mode and then Button Mapping Mode:
1.Make sure the handset is turned off.
2.Press and hold the Select button (") for three seconds.
3.While still holding ", press O.
The handset beeps twice, and the top line of the display shows LCL:P (unless you have already changed it from the default setting).
4.Press and hold "M" (6) for three seconds to enter Button Mapping Mode. The handset display shows one of the following:
MAP:P | PARTNER systems |
MAP:D | DEFINITY systems, System 25, System 75, and System 85 |
MAP:M1 | All MERLIN systems (except MERLIN 410 and MERLIN 820), |
| including MERLIN LEGEND |
MAP:M2 | MERLIN 410 and MERLIN 820 |
5.Press "repeatedly to cycle through the settings until the display appropriate for your communications system is shown.
6.Press Owhen the correct setting is displayed.
The top line of the display shows information appropriate to the communications system you are using.
7.To verify your setting, repeat Steps
PARTNER systems: | LCL:P |
DEFINITY systems, System 25, System 75, | LCL:D |
and System 85 |
|
All MERLIN systems (except MERLIN 410 and | LCL:M1 |
MERLIN 820) |
|
MERLIN 410 and MERLIN 820 | LCL:M2 |
For a description of the button mapping between the MDW 9030P Pocketphone and the wired telephones for your communications system, or to program features on buttons, see "Button Mapping" in Chapter 6.
