Installing a Single Carrier on a Shelf or Desk
■You will not receive optimum performance if unit is placed on a desk or low shelf
■Install as high as possible, leaving
■Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion)
■See “Key Components” earlier in this chapter for additional picture detail
1Perform the tests described in "Wireless Test Mode" earlier in this chapter to determine the
optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.
2
Check to make sure the carrier’s power cord is unplugged from the wall outlet before continuing.
3Remove the plastic cap covering each radio module’s card edge before installing the radio
modules in the carrier.
4Starting from the leftmost slot (#1), insert each radio module into the carrier by hooking it onto
the radio module mounting rod. Slowly swing the radio module's card edge into the card edge connector on the back of the carrier.
