Go to one of the following sections:

If installing one MDW 9030P Pocketphone, go to “Installing a Single Radio Module.”

Otherwise, go to “Setting the Power Level.”

Installing a Single Radio Module

Install high on wall, leaving 6–12 inches (15.2–30.5 cm) between antenna and ceiling

See “Key Components” earlier in this chapter for additional picture detail

1

2

Perform the tests described in "Wireless Test Mode" earlier in this chapter to determine the optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.

Check to make sure the radio module’s power cord is unplugged from the wall outlet before continuing.

3Detach the rubber feet from the shipping card. Apply them to marked areas on the underside

of the radio module.

4Place the wall-mounting plate against the wall. Choose a location backed by a wooden stud (if

unavailable, use toggle bolts instead of the supplied wood screws). Lightly tap a nail into the wall to start holes. Then screw the plate flush to the wall. Place the radio module over the plate, then slide it down- ward to lock it into place. (Note: Do not remove the plastic cap covering the radio module’s card edge.)

Screw

Holes

Installing the MDW 9030P Pocketphone 2-13

Page 25
Image 25
Lucent Technologies Transtalk 9000 manual Installing a Single Radio Module