Lucent Technologies Transtalk 9000 manual 28Installing the MDW 9030P Pocketphone

18Plug each carrier’s power cord into one of the following power sources that is not controlled

by an on/off switch:

■ Properly grounded 3-prong wall outlets

■ Surge suppressor strip

Power the carriers as follows:

If the carriers are plugged into...	Then...
one surge suppressor strip	power the strip.
	Result: All carriers will turn on simultaneously.
wall outlets	plug in the power for all carriers in this order:
	4	4	4

Control	Expansion	Expansion
Carrier	Carrier #1	Carrier #2
1	2	3

!

CAUTION:

Never connect or disconnect expansion cables or telephone line cords, or insert or remove radio modules, while the carrier is plugged into the wall outlet.

19Verify that the carriers’ Out of Sync LEDs are not lit. If an LED is lit, power down and then

repower the carriers as described in Step 18. If the LED is still lit, follow the suggestions in the "Installa- tion Problems" section of Chapter 5, "Troubleshoot- ing." If the LED is still lit, call for help as described on the inside front cover of this book.

		OUT
		YNC
OUT	OF	S
4

Go to “Installation Self-Test.”

2-28Installing the MDW 9030P Pocketphone