Lucent Technologies Transtalk 9000 manual Power and Pass LEDs on

InstallationProblems(continued)

Symptom	Possible Causes	Possible Solutions
After plugging the	Radio modules are out of	Power down the carrier and
carrier into an	synchronization.	repower it. If you have multiple
electrical outlet, the		carriers, repower the control
PASS LED of one or		carrier first, and then power the
more radio modules		expansion carriers in order from
does not light.		left to right.
		If the problem persists, call for
		help.*
	A radio module is malfunc-	1. Remove all but one radio
	tioning.	module from the carrier. (See
		"Removing a Radio Module
		from the Carrier" in Chapter 4.)
		2. Test each radio module indi-
		vidually, verifying that the
		POWER and PASS LEDs on
		each radio module light when
		the carrier is powered.
		3. If the PASS LED does not light,
		the radio module is malfunction-
		ing. Replace the radio module
		and handset.
A defective radio	The radio module was in-	Power down the carrier and
module was	serted without first powering	repower it. If you have multiple
replaced, and now	down the carrier. The carrier	carriers, repower the control
all the handsets	is out of synchronization.	carrier first, and then power the
have less range		expansion carriers in order from
than before, and		left to right.
the voice quality		If the problem persists, call for
has deteriorated.
		help.*
When turned on,	Electrical outlets may not be	Verify that the outlets for the
the handset	up to specifications. Electri-	communications system switch
display shows	cal problems, such as no	and for the carrier(s) meet
lines going on hold	ground or floating ground,	electrical requirements. (See
and line selections	can cause the switch to send	"AC Outlet Check" in Chapter 2.
changing without	or receive spurious current,
any buttons being	causing problems in switch
pressed.	protocol.

* See “Customer Support” on the inside front cover of this book.

Troubleshooting 5-3