Setting the Control/Expansion DIP Switch
You must follow the instructions in this section if you are installing multiple carriers. Other- wise, skip to “Installing a Single Carrier on a Shelf or Desk” or “Installing a Single Carrier on a Wall.”
If you are installing multiple carriers, you must designate one carrier (the leftmost carrier) as the control carrier and the remaining carriers as expansion carriers. The control carrier acts as the “lead”
You set the control/expansion DIP switch, located in Slot 4, to configure the carrier:
N |
|
O | 1 |
Control/Expansion
DIP Switch
1
N | 2 |
O | 1 |
N | 2 |
O | 1 |
2 | 3 | 4 | 5 |
Slot 4
Use a nonmetallic, pointed object to set each carrier’s DIP switch according to the following table.
IMPORTANT:
Only one carrier (the leftmost carrier) can be the control carrier; the other carriers must be expansion carriers.
To designate the carrier as a...
control carrier (one carrier only)
expansion carrier (one or two additional carriers)
Use this setting for the DIP switch...
O NO N
Go to “Installing Multiple Carriers.”
