Lucent Technologies Transtalk 9000 manual Antenna, Changing the Handset Settings

Antenna

The MDW 9030P Pocketphone comes with a user-replaceable, flexible, retractable antenna. For maximum range and voice quality, always fully extend the antenna before placing or answering a call. You can receive a call (if you are within range of the radio module) without extending the antenna, but you may get a RANGE indication. The antenna must be fully extended for optimal performance.

Changing the Handset Settings

You can use Local Mode to change the handset settings for these functions:

■Communications system button mapping

■Vibrator

■Line Preselection

■Alerter

Local Mode also gives you access to Local Test Mode (which enables you to test the alerter, vibrator, and display) and Wireless Test Mode (which enables you to test sound clarity, signal strength, and voice quality). While in Local Mode, the MDW 9030P can still receive notification of incoming calls.

To access Local Mode, use the following procedure:

1.Make sure the handset is turned off.

2.Press and hold the Select button (") for three seconds.

3.While still holding ", press O.

The handset beeps twice, and the display shows the handset settings. For example, the following display indicates that the handset:

■Is using button mapping for a PARTNER switch

■Has the vibrator and Line Preselection enabled

■Has the alerter disabled

To exit Local Mode, press O.

Changing the Communications System Button Mapping Setting

If the MDW 9030P Pocketphone is set to use the wrong communications system, an error message saying CHANGE BUTTN MAP shows on the top line of the handset display each time the Obutton is pressed. If you see this message, use the procedure described in "Changing the Communications System Setting" in Chapter 2 to specify the correct communications system setting.

3-8Using the MDW 9030P Pocketphone