Lucent Technologies Transtalk 9000 Inserting the Handset into Battery Chargers Handset Cradle

Inserting the Handset into the

Battery Charger's Handset Cradle

Correct positioning of the handset in the charger is important to ensure proper charging.

1Position the handset (with its battery pack attached) so that the two small round holes in the bottom of the handset fit over the two guide pins on the bottom of the handset

cradle.

2

Rock the handset back into the cradle until it is firmly seated with the back of the handset battery pack against the back of the handset cradle.

When the handset has been inserted correctly, the following occur:

■The HANDSET LED lights.

■If the handset was turned on, the ON icon in the display is no longer visible.

■Any call that was in progress is terminated.

■After 15 seconds, the handset enters the energy-saving "sleep" mode.

On/Off	Redial		Mute
Feat/P	1		2ABC		3DEF
Conf		4GHI
				5JKL
					6MNO
Trans		7PQRS
				8TUV	9WXYZ
Hold
				0OPER

	SPARE	HANDSET
Guide Pins		REFRESH

Removing the Handset from the Handset Cradle

	On/Off		Redial		Mute
	Feat/P		1		2ABC
							3 DEF
	Conf
			4 GHI		5 JKL
							6MNO
	Trans	7PQRS
				8 TUV
						9WXYZ
	Hold
				0OPER
SPARE	HANDSET
					REFRESH

HANDSET LED

To remove the handset from the handset cradle, simply lift it out.

2-36Installing the MDW 9030P Pocketphone