Lucent Technologies Transtalk 9000 manual Range Problems

Range Problems (continued)

Symptom	Possible Causes	Possible Solutions
(Continued)
Handset voice quality	Electromagnetic fields	Look for 110/Volt lines, fuse boxes,
and range are not as	are interfering.	circuit breakers, electrical junction
good as they were		boxes, or similar items. Move the
before.		carrier or radio module at least 6
		feet (1.8 cm) away from the potential
		interference.
	There is a large metal	Move the carrier or radio module at
	object within 3 feet	least 3 feet (1.2 m) away from the
	(1.2 m) of the radio	potential interference.
	module.
	There is a large metal	Move the metal object, or move the
	object in the "line of	carrier or radio module.
	sight" to the radio
	module.
After pressing Oto	Handset is out of range	Move the handset closer to the
turn the handset on,	of its matching radio	radio module.
the handset beeps and	module.
RANGE shows in the
	An electrical device is	Remove the interfering device or
handset display.
	interfering with your	power it off, or move the handset
	communications link.	to another location.
Range for calls is	The handset antenna is	Fully extend the handset antenna.
lower than expected.	only partially extended.
	There are environmental	Reinstall the radio module or
	limitations.	carrier away from electrical
		equipment and as high as pos-
		sible on the wall (but with radio
		module antennas 6–12 inches
		(15.2–30.5 cm) from the ceiling).
		See “General Positioning Rules” in
		Chapter 2 for more information.
	You are using different	See "TransTalk 9000 System" in
	models of handsets and	Chapter 1.
	the mix is incompatible
	with the carrier.

Troubleshooting 5-11