Lucent Technologies Transtalk 9000 manual Positioning the Battery Charger

Battery Charger

This section explains how to choose a location for the battery charger and install it. It also explains how to insert and remove a battery pack.

Positioning the Battery Charger

The battery charger can be placed on a desk, or it can be mounted on a wall. Before you install the battery charger, note the following considerations:

■Locate the battery charger within 5 feet (1.6 m) of a properly grounded 3-prong electrical outlet that is not controlled by an on/off switch.

■If your communications system uses an uninterruptable power supply, such as a backup generator, you may want to connect the battery charger to that power supply.

■Do not locate the battery charger where it will be exposed to direct sunlight or water.

WARNING:

The rechargeable battery pack may contain elements that are harmful to the environment (for example, nickel). Do not burn or puncture the battery. Like other batteries of this type, if it is burned or punctured, it could release toxic material that could cause injury. Do not dispose of it in household garbage. For information about recycling or proper disposal, consult your local solid waste (garbage) collection or disposal organization.

Installing the Battery Charger

■If you are wall-mounting the battery charger, follow Steps 1 through 7

■If you are desk-mounting the battery charger, follow only Steps 1, 5, and 7

1

Check to make sure the battery charger’s power cord is unplugged from the wall outlet before continuing. If you are desk-mounting, skip to Step 5.

2To wall-mount, place the battery charger's wall-mounting template (located on the last page of this book) against the wall. Choose a location backed by a wooden stud (if

unavailable, use toggle bolts instead of the supplied wood screws). Hold the template straight; use a level if needed.

3

Mark the locations for the two wall-mounting screws, and then remove the template from the wall. Lightly tap a nail into the wall to start the holes.

4Place the screw through the wall spacers so that the screw head nests in the indenta- tion on the spacer. Start the screws, and screw them in until the wall spacers rest

against the wall.

Installing the MDW 9030P Pocketphone 2-33