ENGLISH
SECTION 2 - INSTALLATION |
|
VI. CONVEYOR INSTALLATION | Figure |
Refer to either Step A or Step B in this section, as appropriate, to install the conveyor and belt.
A. InstallingtheConveyor-AllovensEXCEPTTandem models
NOTE
Split belt conveyors can only be installed from the end of the oven with the drive motor.
To remove the drive sprocket (if necessary), loosen the set screw |
|
|
on the conveyor collar as shown in Figure |
|
|
sprocket assembly straight out. |
| Loosen conveyor collar |
1. Lift the conveyor and position it in the oven as shown in |
| set screw, then pull shaft |
| straight out | |
Figure |
|
|
Figure |
| |
1 | 2 | 3 |
2.Continue moving the conveyor into the oven until the frame protrudes equally from each end of the oven (about 18"/ 457mm).
3.Check that the retainers located on the underside of the conveyor frame rest firmly against the lower end plug, as shown in Figure
NOTE:
PS360EWB ovens have a retainer bracket that extends the full width of the conveyor frame on both ends of the frame. All other ovens have retainer clips as shown in Figure
4.When the conveyor is positioned properly, check for free- dom of movement of the conveyor belt by pulling it for about
5.If the drive sprocket was removed when installing the conveyor, replace it at this time.
6.Install the drive chain between the conveyor drive sprocket and the motor sprocket. To install the chain, it will be necessary to lift the drive end of the conveyor slightly. The drive motor and sprocket are shown in Figure
7.Install the conveyor drive motor cover and tighten its hanger screw (on the rear wall of the oven).
8.Check the tension of the conveyor belt as shown in Figure
NOTE:
If necessary, the belt tension can be adjusted by turning the conveyor adjustment screws, located at the idler (right) end of the conveyor. See Figure
Figure
Retainers on both ends of
PS360EWB, drive side only for all other ovens
Figure
vertical deflection
Conveyor
tension
adjustment
screws (idler
end only)
12