Motorola G24 +MFS, Motorola Frequency of Search

Chapter 3: AT Commands Reference
June 30, 2008 AT Commands Reference Manual 3-179
+MFS, Motorola Frequency of Search
This command is used to determine how long the G24 waits before attempting to reregister after a
registration attempt has failed and the G24 is not registered. The available settings are Slow
Search, Medium Search, Fast Search or Continuous Search.
See Table3-106, “+MFS P arameters”, for the minimum interval lengths for every frequency of
search. The interval between attempts can vary, depending on the number of operators displayed
in the preferred operator list.
This command sets or reads Frequency of Search and Search mode settings. After a Set command
has been executed, new Frequency of Search and Search mode values are active.
This command is a non-basic command, which means that the G24 module rejects the command
with an appropriate error message when the SIM is not present and/or the phone is in lock state.
Command Type Syntax Response/Action Remarks
Set +MFS=<freq>
[,<mode>] OK
or:
+CME ERROR: <err>
This command enables you to change
and store in Flex the new values of
Frequency of Search <freq> and
Search mode <mode>.
If only the <freq> value is given, then
the Set command is interpreted as
follows:
• Store new <freq> value. The
<mode> value remains unchanged.
If <freq> and <mode> values are
given, then the Set command is
interpreted as follows:
• Store new <freq> and <mode>
values.
Otherwise, an error message is sent to
the DTE.
Note: If the phone is not registered,
then a set operation of Search
mode to Manual is refused and
ERROR is sent to the DTE.
Read +MFS? +MFS: <freq>,<mode>
OK
or:
+CME ERROR: <err>
The Read command returns the current
settings for values of <freq> and
<mode>.
Test +MFS=? +MFS: (List of
supported <freq>,(List
of supported <mode>s)
OK
or:
+CME ERROR: <err>
The Test command returns the possible
<freq> and <mode> values.