Network
3-190 AT Commands Reference Manual June 30, 2008
Max bit rate dl Max bit rate for Downlink in KPBS.
Max bit rate ul Max bit rate for Uplink in KPBS.
MCC Mobile Country Code.
MNC Mobile Network Code.
MaxTxPWR The maximum power (sent on System Info 3 and PSI 3) that the phone is allowed
to transmit while sending channel request messages.
Network control order This indicates whether the MS performs GPRS measurement reports and whether,
in the ready state, the reselection is network- or MS-controlled.
Possible values are: 0, 1, 2.
Network operation
mode GSM 03.60 network operation mode (1, 2 or 3), from System Info 13.
PC_meas_chan GPRS flag that indicates whether the downlink measurements for power control
are made on BCCH or PDCH. This is broadcast on System Info 13 rest octets.
PCR Packet Channel Request. Type of request used to set up an Uplink TBF.
Penalty time Indicates for how long the temporary offset will be applied. The time is calculated
as follows: (Penalty_time+1)*20 in seconds. Value 31 has a special meaning, and
will be displayed differently in the future.
Power offset Power offset in dBm.
priority_access_thr I ndicates the radio priority of the transfer.
Radio priority Radio priority of the current PDP context.
Repeated
downlink/uplink
blocks
Number of RLC blocks repeated (either in the uplink or downlink direction,
depending on the screen). Repeated RLC frames are NOT taken into account
when calculating the average throughput.
Repeated
downlink/uplink
frames
Number of LLC frames repeated (either in the uplink or downlink direction,
depending on the screen). Repeated LLC frames are taken into account when
calculating the average throughput.
Residual ber Undetected bit error ratio in the delivered SDUs.
RLT Radio Link Time-out, from System Info 3.
RxLev Received signal level, in dBm. This parameter comes in several forms that have
different meanings. Note that RxLev, Rx_Lev_Full and Rx_Lev_Sub are all
calculated by the phone, but RxLev access min is sent by the serving cell (on
System Info 3).
Rx_Lev_Full Signal strength of the beacon channel of the serving cell.
Rx_Lev_Sub Signal strength of the active dedicated channel.
RxLev access min The minimum access RxLev of the cell currently being viewed.
RxQual Received signal quality. This parameter may concern two channels.
Rx_Qual_Full The base channel (carrying the BCCH).
Rx_Qual_Sub The dedicated active channel.
Table 3-122:EFEM Parameters (Cont.)
Abbreviation/Term Description