Motorola G24 The following table shows the +MIOD parameters., The following table shows the keypad GPIOs. , Table 3-143: +MIOD Parameters, Table 3-144:Keypad GPIOs

Chapter 3: AT Commands Reference
June 30, 2008 AT Commands Reference Manual 3-223
The following table shows the +MIOD parameters.
The following table shows the keypad GPIOs.
Table 3-143: +MIOD Parameters
<Parameter> Description
<pin selection> Selected pins for the action invoked. This is a binary vector in which each bit points to
pin number. Vector size is 8.
0 Not selected
1 Selected pin (default)
<mode> GPIO pin operation mode.
0 Output (level only)
1 Input (level mode)
<mode vector> This is a binary vector in which each bit shows the operation mode of pin. Data vector
size is 8.
0 Output (level only)
1 Input (level mode)
The default value:
On Power Up - as previously saved in FLEX bytes.
Before set command first used - 1. (This means that all lines are configured as Input
before set command first used).
<data vector> This is a binary vector in which each bit shows the physical value of pin. Data vector
size is 8.
0 Physical low signal.
1 Physical high signal (default).
The default value:
On Power Up - as previously saved in FLEX bytes.
Before set command first used with <Data vector> and <Mode>=0, or after +MIOD
without <Data vector> and before +MIOD command used - 1.
Table 3-144:Keypad GPIOs
GPIO
Name
70 PIN
connector,
PIN#
GPIO
Number
KBC1 28 1
KBC0 30 2
KBR0 32 3
KBR1 34 4
KBR4 36 5
KBR5 38 6
KBR6 40 7
KBR7 42 8