Motorola SBG940 manual 129

Overview Installation Troubleshooting	Contact	FAQ	Specifications	Glossary	License
Configuration: Basic	Gateway	TCP/IP	Wireless USB

switch	On an Ethernet network, a switch filters frames based on the MAC address, in a manner similar to a
	bridge. A switch is more advanced because it can connect more than two segments.
symbol rate	Also known as baud rate, is a measure of the number of times per second a signal in a
	communications channel varies, or makes a transition between states (states being frequencies,
	voltage levels or phase angles). Usually measured in symbols per second (sps).
SYSLOG	A de-facto UNIX standard for logging system events.

T

TBCP	Tagged Binary Communication Protocol
TCP	Transmission Control Protocol on OSI transport layer four, provides reliable transport over the network
	for data transmitted using IP (network layer three). It is an end-to-end protocol defining rules and
	procedures for data exchange between hosts on top of connectionless IP. TCP uses a timer to track
	outstanding packets, checks error in incoming packets, and retransmits packets if requested.
TCP/IP	The Transmission Control Protocol/Internet Protocol suite provides standards and rules for data
	communication between networks on the Internet. It is the worldwide internetworking standard and the
	basic communications protocol of the Internet.
TFTP	Trivial File Transfer Protocol is a very simple protocol used to transfer files.
TKIP	Temporal Key Integrity Protocol
transparent	A method to enable all hosts on the wired Ethernet LAN, WLAN, and USB connection to communicate
bridging	as if they were all connected to the same physical network.
transport layer	Layer of the OSI concerned with protocols for error recognition and recovery. This layer also regulates
	information flow.
trunk	Electronic path over which date is transmitted.
TTL	The time to live is the number of routers (or hops) a packet can traverse before being discarded. When
	a router processes a packet, it decreases the TTL by 1. When the TTL reaches zero, the packet is
	discarded.
tunnel	To place packets inside other packets to send over a network. The protocol of the enclosing packet is
	understood by each endpoint, or tunnel interface, where the packet enters and exits the network.
	VPNs rely on tunneling to create a secure network.
	Tunneling requires the following protocol types:
	• A carrier protocol, such as TCP, used by the network that the data travels over
	• An encapsulating protocol, such as IPSec, L2F, L2TP, or PPTP, that is wrapped around the original
	data
	• A passenger protocol, such as IP, for the original data
two-way	A cable system that can transmit signals in both directions to and from the headend and the
	subscriber.
To return to your previous page, click the Acrobat Go to Previous View		button.

Home Print

X	129	SBG940 User Guide
Exit