Muratec F-114 Series manual Copying Problems, Curl

	Condition	Suggested solutions
Character Voids		Character voids are white areas within the parts of
		characters that should be solid black:
	A	• If you are using transparencies, try another type of
		transparency. Due to the composition of the transparency,
		some character voids are normal.
		• You may be printing on the wrong surface on the paper.
		Remove the paper and turn it around.
		• The paper may not meet paper specifications. See “Paper
		Specifications” on page A.6.
Horizontal stripes		If horizontally aligned black streaks or smears appear:
		• The toner cartridge may be installed improperly. Remove and
	AaBbCc	reinsert the cartridge.
	AaBbCc	• The toner cartridge may be defective. Remove the toner
	AaBbCc	cartridge and install a new one. See “Replacing the Toner
		Cartridge” on page 8.9.
	AaBbCc
		• If the problem persists, the machine may require repair.
	AaBbCc	Contact a service representative.
	Curl	If the printed paper is curl or paper does not feed into the
		printer:
		• Turn the stack of paper over in the paper tray. Also try
		rotating the paper 180° in the paper tray.
		• Try printing to the rear output slot.

Copying Problems

Condition	Suggested solutions
Copies are too light or too	Use the Darkness button to darken or lighten the
dark.	background of the copies.
Smears, lines, marks or	• If defects are on the original document, press the
spots appears on copies.	Darkness button to lighten the background of your
	copies.
	• If no defects are on the original document, clean the
	Scan unit. See page 8.5.	9
Copy image is skewed.	• Ensure that the original document is positioned
	correctly in the ADF (Automatic Document Feeder).
	• Check that the copy paper is loaded correctly.
Blank copies print out.	Ensure that the original document is face down in the
	ADF.

TROUBLESHOOTING 9.19