Muratec F-114 Series manual Operation Not Cancel operation, but there, Assigned Is no jobs waiting

Display		Meaning	Suggested solutions
[No Paper]	The paper tray has run out		Load paper in the paper tray.
Add Paper	of paper.		See page 1.12.
	You are doing in the Add/		Check the display to see if there
Operation Not	Cancel operation, but there		is any scheduled job. The display
Assigned	is no jobs waiting.		should indicate them in Standby
			mode, for example, Delay Fax.
[Paper Jam 0]	Paper has jammed in the		Clear the jam. See page 9.4.
	feeding area of the paper
Open/Close Door
	tray.
	•	Paper has jammed in	Clear the jam. See page 9.6.
		the paper exit area.
[Paper Jam 1]	•	A paper jam has
		occurred in the manual
Open/Close Door
		feeder or the machine
		detects non-feeding
		from the manual feeder.
[Paper Jam 2]	Paper has jammed in the		Clear the jam. See page 9.5.
Check Inside	fuser area.
	Power has turned off then on		You need to start again the job
Power Failure	and the machine’s memory		which you were trying to do
	has not been saved.		before the power failure.
	The machine is waiting for a		You can press Enter to
Retry Redial?	specified time interval to		immediately redial, or Stop/
	redial a previously busy		Clear to cancel the redial
	station.		operation.
	The Stop/Clear button is		Try again.
[Stop Pressed]	pressed during a copy or fax
	operation.
	The toner cartridge has run		Replace with a new toner
[Toner Empty]	out. The machine stops		cartridge. See page 8.9.
	printing.
	The toner cartridge is almost		Take out the toner cartridge and
[Toner Low]	empty.		gently shake it. By doing this,
			you can temporarily reestablish
			printing operations.

9.10TROUBLESHOOTING