Sheet 2/7
System Initialization and
System Data Entry
2.SYSTEM DATA ENTRY
•There are two methods for data entry, both of which employ a Customer Administration Terminal (CAT) or a Maintenance Administration Terminal (MAT).
2.1 CAT
Any multiline terminal can be assigned as a CAT terminal through programming. The multiline terminal can still be used as a regular telephone when it is not in CAT mode. If the system is initialized by “C” (Resident System Pro- gram), every multiline terminal will be able to go into CAT mode. If the system is initialized by “B” (All Clear), only LEN0000 is assigned as a CAT port (the DLC card must be installed in slot LT00).
The following procedures provide actions to set up a multiline terminal as a CAT.
To set CAT mode:
(1)Press
(2)Press
TRF
CNF
- CNF lamp flashes.
(3) Press
*
- CNF lamp is off.
(4) Press
TRF
(5) Press
CNF
- CNF lamp flashes.
(6) Press
#
-CNF, SPKR, ANS lamps are lit.
-“CAT MODE” displays on the LCD.
(7) Press
ST
- “COMMAND =
Note: It is necessary to complete Steps 1 through 6 within 4 seconds.
NDA-24219 CHAPTER 3
Page 119
Revision 2.0
