![](/images/new-backgrounds/1289164/289164273x1.webp)
Sheet 6/7
System Initialization and
System Data Entry
(2) Programming Procedure for Pushbutton Calling
START | DESCRIPTION |
| DATA |
CM10
Assign the Card Number of internal PB Receiver to | (1) | LEN: 0124 | |
the LEN No. 0124. | INITIAL | (2) |
CM12
CM45
Note: When using the internal PB Receiver on |
|
|
the MP card, assign the Card No. E200- |
|
|
E203 to the LEN No. 0124. |
|
|
If resident load is used, PB Receiver ports |
|
|
|
| |
signed. |
|
|
Assign the type of telephone set (DTMF) to DTMF | . | YY = 00 |
Stations. | (1) | |
This data assignment is not required for Multiline | (2) | 2 : DTMF Telephone set |
Terminal station. |
|
|
Assign PB Receivers for use with DTMF | . Y = 0 (Make Busy) | |
Stations. | (1) | XX X |
Circuit No. 0-3
Card No. 00-03 assigned by
CM10(E200-E203)
(2) :Make Busy Cancel
. Y = 1 (Purpose)
A(1) XXX (Ditto to Y = 0)
(2) 1 :For both DTMF station and Tie Line/
DID
NDA-24219 CHAPTER 3
Page 123
Revision 2.0