NEC NEAX1000IVS Removing/Inserting Circuit Cards, Procedure Circuit Card Condition Insert Remove

1.3Removing/Inserting Circuit Cards

When removing a circuit card from the PIM or when inserting a circuit card in the PIM, follow the procedure in Table 3-1.

Table 3-1 Removing/Inserting Circuit Cards Procedure

		PROCEDURE
	CIRCUIT CARD			CONDITION
		INSERT	REMOVE
•	PN-CP03 (MP)	Power off	Power off	Always insert or remove these circuit cards
•	PZ-PW86 (PWR)	↓	↓	with power off to prevent damage to the card
•	PZ-PW112 (PWR)	Insert	Remove	or other system circuitry.
•	PN-PW00	↓	↓
		Power on	Power on
•	PN-AP00 (AP00)			Always insert or remove these circuit cards
•	PN-ME00 (EXTMEM)			under Make Busy condition or power off to
•	PN-BRTA (BRT)			prevent damage to the card or other system
•	PN-BS00-B (BS00)			circuitry.
•	PN-BS01-B (BS01)	Power off or	Power off or
•	PN-CK00 (PLO)	MB switch on
			MB switch on
•	PN-24DTA-A (DTI)	↓
			↓
•	PN-4RSTB (MFR)	Insert
			Remove
•	PN-4RSTC (CIR)	↓
			↓
•	PN-SC00 (CCH)	Power on or
			Power on
•	PN-SC01 (DCH)	MB switch off
•	PN-SC02 (ICH)
•	PN-SC03 (ICH)
•	PN-SC03 (CSH)
•	PN-VM00
•	PN-AP01 (AP01)	Refer to the OAI System Manual.
•	PN-CC00 (ETHER)

CHAPTER 3 NDA-24219

Page 22

Revision 2.0