CHAPTER 4 OFFICE DATA PROGRAMMING

1. CUSTOMIZING DATA

1.1Data Programming Procedure

Table 4-1shows the procedure and the outline of the work related data programming for the system.

Table 4-1 Data Programming Procedure

STEP

WORK

REMARKS

 

 

 

1

Obtain the customer’s requirements, and fill in the

 

Customer Specification Sheets on Section 1.3.

 

 

 

 

 

 

 

Allocate the LC, TRUNK and other interface cards to

 

2

the Port Assignment Table on Section 1.2.7. Make a

 

Bay Face Layout on Section 1.4.2 for accommodating

 

 

 

 

cards required in the system.

 

 

 

 

 

Fill in the data programming sheets on Section 2 with

For programming method and detailed information on

3

the Customer Specification Sheet, Port Assignment

commands, refer to the Command Manual.

Table and Bay Face Layout completed as steps 1 and

 

 

 

 

2.

 

 

 

 

4

Ensure that the data on all programming sheets are

 

correct and consistent with customer specifications.

 

 

 

 

 

 

5

Specify the switch setting on the boards with the

For the function of each switch on the cards, refer to

Switch Setting Table in the Circuit Card Manual.

the Circuit Card Manual.

 

 

 

 

1.2General Information on Customizing Data

1.2.1Numbering Plan

This table specifies the service feature access codes, trunk access code, station numbers and other special access codes. The service feature access codes and trunk access codes are given to each service feature and each trunk routes, respectively, with a maximum three-digit code. The station numbers are specified by a maximum of four dig- its.

For the numbering plan of the system the following conditions should be considered.

(1)The same first digit code cannot be assigned to the other features within the Numbering Plan Group pro- grammed. (This condition is not applicable to the system providing the Single Digit Timing Start Access.)

(2)The feature access codes should be two or three digits because multiple access codes for each feature are required.

(3)There are four types of station numbering (1 digit – 4 digits), and any combination of these types is avail- able in one system.

(4)The same station number cannot be assigned, even if the tenant service is applied.

NDA-24219CHAPTER 4

Page 129

Revision 2.0

Page 143
Image 143
NEC NEAX1000IVS Data Programming Procedure, General Information on Customizing Data Numbering Plan, Step Work Remarks